Справочник Пользователя для DELL powervault e03j001

Installing Enclosure Components

31

Installing a Drive Blank

1 If installed, remove the front bezel. See "Removing the Front Bezel" on 

2 Insert the drive blank into the drive bay until the blank is fully seated. 
3 Close the handle to lock the blank in place.
4 If applicable, replace the front bezel. See "Installing the Front Bezel" on 

Removing a Hard Drive

 

CAUTION: 

Many repairs may only be done by a certified service technician. 

You should only perform troubleshooting and simple repairs as authorized in 
your product documentation, or as directed by the online or telephone service 
and support team. Damage due to servicing that is not authorized by Dell is not 
covered by your warranty. Read and follow the safety instructions that came with 
the product.

1 If installed, remove the front bezel. See "Removing the Front Bezel" on 

2 From the management software, prepare the drive for removal. Wait until 

the hard-drive indicators on the drive carrier signal that the drive can be 
removed safely. For more information, see your controller documentation 
for information about hot-swap drive removal.
If the drive has been online, the green activity/fault indicator flashes as 
the drive is powered down. When the drive indicators are off, the drive is 
ready for removal. 

3 Press the release button to open the drive carrier release handle. See 

4 Slide the hard drive out until it is free of the drive bay.

 

CAUTION: 

To maintain proper system cooling, all empty hard-drive bays must have 

drive blanks installed. 

5 Insert a drive blank in the empty drive bay. See "Installing a Drive Blank" 

6 If applicable, replace the front bezel. See "Installing the Front Bezel" on 

book.book  Page 31  Monday, December 7, 2009  4:51 PM