Справочник Пользователя для JVC GR-DX78

MasterPage: Advan_Right

Press PLAY (U) and then press R.A.EDIT ON/OFF on 

the remote control.

● The Random Assemble Editing 

Menu appears.

If using a Wipe/Fader at the 

beginning of the scene, press 
FADE/WIPE on the remote 
control.

● Cycle through the effects by 

pressing repeatedly, and stop 
when the one you want is 
displayed.

At the beginning of the scene, press EDIT IN/OUT on 

the remote control. The Edit-In position appears in the 
Random Assemble Editing Menu.

At the end of the scene, press EDIT IN/OUT. The Edit-

Out position appears in the Random Assemble Editing 
Menu.

If using a Wipe/Fader at the end of the scene, press 

FADE/WIPE.

● Cycle through the effects by pressing repeatedly, and stop 

when the one you want is displayed.

● If you select a Wipe/Fader effect for an Edit-Out point, the 

effect is automatically applied to the following Edit-In point.

● When you use Wipe/Fader effects, that time is included in 

the total time.

If using Playback Special Effects, press EFFECT. 

Repeat steps 

8 through 11 to register additional 

scenes.

● To change previously registered points, press CANCEL on 

the remote control. The registered points disappear, one at 
a time, from the most recently registered point.

● If you are not using Wipe/Fader or Program AE with special 

effects, repeat steps 

8 and 9 only.

● When choosing a scene, set Edit-In and Edit-Out points so 

that there is a relatively large difference between them.

● If the search time for an in-point exceeds 5 minutes, the 

recording deck’s Record-Standby mode will be cancelled 
and editing will not take place.

● If there are blank portions before or after the Edit-In and 

Edit-Out points, a blue screen may be included in the edited 
version.

● Turning off the camcorder’s power erases all registered 

Edit-In and Edit-Out points.

● If you select Sepia or Monotone mode from Program AE 

with special effects, you cannot use the Black & White 
Fader. In this case the Black & White indicator begins 
blinking. Once the next Edit-In point is registered, the effect 
is turned off. To combine these effects, use Sepia or 
Monotone during recording, then use Black & White Fader 
during Random Assemble Editing.

● It is not possible to use Wipe/Fader effects and Program AE 

with special effects during Random Assemble Editing using 
a DV cable.

GR-DX78PAL.book  Page 43  Tuesday, January 6, 2004  3:27 PM