Справочник Пользователя для Echo HC-235

Hedge Clipper blades are very sharp.  Touching them may lead to 

severe personal injury.  Avoid touching blades whenever possible, 

and always wear gloves to protect hands. 

The blade cover is used for transportation and storage. Remove 

blade cover before using the unit.

1.  Stop Switch

  Move stop switch (A) away from the STOP position.

2.  Choke 
  Move choke (B) to the Cold Start (

 ) (CLOSED) position.

3.  Purge Bulb

  Pump purge bulb (C) until fuel is visible and flows freely in the 

clear fuel tank return line. Pump bulb an additional 4 or 5 times.

4.  Recoil Starter 

  Lay the unit on a flat, clear area. Grip the support handle securely 

with right hand, and pull the recoil starter handle (D) with left hand 

until engine fires (or 5 pulls maximum).

5.  Choke 

  After engine fires or 5 pulls, move choke (B) to the RUN    

(

) (OPEN) position. Restart engine if necessary and allow unit 

to warm up at idle for several minutes.

If engine does not start with choke in “Run” position after 5 pulls, 

repeat instructions 2 - 5.

The blades must not move at idle, otherwise serious personal 

injury may result. Periodic carburetor adjustment may be necessary 

to assure blades do not move at idle.  

If blades move, readjust carburetor according to “Carburetor Ad-

justment” instructions in this manual or see your ECHO Dealer. 

6.  Throttle Trigger

  After engine warm-up, grip the throttle handle with left hand and 

support handle with right hand. Depress the throttle trigger lockout, 

and gradually depress throttle trigger (E) to increase engine RPM to 

operating speed.