Справочник Пользователя для Echo SRM-211i

Level 2.

T-Wrench, feeler gauge, soft metal brush

Parts Required: REPOWER

TM

 Tune-Up Kit P/N 90074C

1. Remove spark plug and check for fouling, worn and rounded

center electrode.

2. Clean the plug or replace with a new one.  DO NOT sand blast to

clean. Remaining sand will damage engine.

3. Adjust spark plug gap by bending outer electrode.

4. Tighten spark plug to 145 - 155 kg/cm (125 - 135 in. lb.).

Level 2.

Cross-head screwdriver, 3 and 4 mm hex wrench,
25 - 50mm (1 - 2 in.) cleaning brush

Parts Required: None if you are careful.

IMPORTANT
To maintain proper engine operating temperatures, cooling air
must pass freely through the cylinder fin area. This flow of air
carries combustion heat away from the engine.

Overheating and engine seizure can occur when:
• Air intakes are blocked, preventing cooling air from reaching the

cylinder.

• Dust and grass build up on the outside of the cylinder. This build up

insulates the engine and prevents the heat from leaving.

Removal of cooling passage blockages or cleaning of cooling fins is
considered “Normal Maintenance”.  Any failure attributed to lack of
maintenance is not warranted.