Справочник Пользователя для Philips mc-30
16
English
3140 115 27913
Tape Recorder
Tape playback
1
Select TAPE source.
➜ The display shows TAPE briefly. The tape
counter
counter
TAPE 000 display with the
A
or
B
and
reverse mode status are then shown during tape
mode.
mode.
2
Press OPEN to open the tape door.
3
Insert a recorded tape and close the tape door.
¶ Load the tape with the open side downward and
the full spool to the left.
4
Press
2; (on the remote control 2) to start
playback.
5
By pressing à or á on the remote control, fast
winding of tape is possible in both directions.
winding of tape is possible in both directions.
¶ To review and cue at low volume, press
REW à /
¡ or FWD á / ™ on the system.
¶ During fast winding or review/cue you can
monitor the tape message with the tape counter.
Release the fast wind/cue control at your desired
passage.
Release the fast wind/cue control at your desired
passage.
6
To stop the tape, press
9 .
¶ To reset the tape counter, press 9 again.
Note:
– The sound source cannot be changed while
recording a tape.
– The sound source cannot be changed while
recording a tape.
Switching tape sides
The tape side can be switched manually or
automatically before or during tape playback.
automatically before or during tape playback.
¶ Press SIDE A/B (SIDE/; or during playback
only
2 on the remote control).
➜ The display shows
A
or
B
and the tape
counter resets to
000.
Reverse mode options
¶ Press REV MODE once or more to select your
option;
å : playback stops at the end of the tape.
å : playback stops at the end of the tape.
∂ : both sides are played once.
∫ : both sides are played repeatedly, up
to 5 times each side.
General Information on
Recording
Recording
¶ Recording is permissible insofar as copyright or
other rights of third parties are not infringed.
¶ For recording, use only NORMAL (IEC type I)
cassette on which the tabs have not yet been
broken. This deck is not suited for recording on
METAL (IEC IV) type cassettes.
broken. This deck is not suited for recording on
METAL (IEC IV) type cassettes.
¶ The best recording level is set automatically.
Altering the VOLUME, INCREDIBLE
SURROUND or DBB controls will not affect the
recording in progress.
SURROUND or DBB controls will not affect the
recording in progress.
¶ At the very beginning and end of the tape, no
recording will take place during the 7 seconds
when the leader tape passes the recorder heads.
when the leader tape passes the recorder heads.
¶ To protect a tape from accidental erasure, have
the tape in front of you and break out the left
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.
TUNING
RDS/ CLOCK
SIDE A/B
VOLUME
SHUFFLE
SOURCE
TIMER ON•OFF PROGRAM
REPEAT
REV MODE
/ BAND
STANDBY-ON
RECORD
M C - 3 0 M I C R O S Y S T E M
iR
OPEN
FWD á
/ë
REW à
/í
PRESET
STOP
PLAY•PAUSE
pg 001-021/MC30/22-Eng
12/7/00, 1:33 PM
16