Справочник Пользователя для Pelco C1572M

 

C1555M-F (10/05)

17

 

The following rear panel cards can be used with the CM9770-MXB matrix bay: 

•

CM9770-RPC—the BNC card for video connections

•

CM9770-RPM—the BNC card for monitor connections

•

CM9770-DFC—this is a downframe card and cable assembly used to connect multiple matrix bays; refer to the 

 

 section in the 

 

 for more information

•

CM9770-DFL—this downframe card and cable assembly is the same as the CM9770-DFC, except that it also has BNC connectors for 
looping inputs; refer to the 

 

 

 for more information 

 

1. Slide the video BNC card into the card guides at the rear of the bay. From the rear of the bay, the slot at the far right provides the connection 

2. Push the BNC card into place firmly.

3. Tighten the screws at the top and bottom of the BNC card.

 

1. Loosen the screws at the top and bottom of the BNC card. Refer to Figure 7.

2. Pull the BNC card towards you until it is out of the frame.

 

 

 

 You will note that the video BNC card consists of two cards connected into one unit. Each video BNC card (CM9770-RPC) provides 

32 video input connections and connects to one video input card (CM9770-VCC).

 

Insert a Rear Panel Video BNC Card  (CM9770-RPC)

 

Remove a Rear Panel Video BNC Card (CM9770-RPC)

TWO RPC CARDS ARE
CONNECTED INTO ONE
UNIT - LOOSEN SCREWS
AT TOP AND BOTTOM TO
REMOVE RPC UNIT