Справочник Пользователя для Pelco C579M

PROGRAMMING AND CONFIGURATION

CM9760-SAT

 The illustrations in this section represent the functional rela-

tionships of the equipment mix needed to accommodate each pro-
gramming choice that is discussed in the associated text.

 In those instances where we discuss procedures or actions

yet to be covered in the manual, we either give a sufficiently adequate
(but abbreviated) discussion, or refer you to the appropriate manual
reference.

 Program the 

 from the 

 only.

Programming Diagram One

You can program the CM9760-SAT from the 

, using a local

keyboard and monitor, or you can program the 

  from the 

, using a 9760-KBD and a system monitor assigned to that opera-

tor. These two basic programming methodologies are not, however,
mutually exclusive. By that, we mean, choosing to program from one
location does not necessarily exclude programming from the other. In-
termediate variations to programming on just one side or the other are
possible.

Interspersed with these programming setups is the need to integrate
what is going to be programmed where, and by whom, given the various
configurations of equipment possible. In the illustrations and explana-
tions below, we discuss some of these variations and indicate advan-
tages, disadvantages and/or tradeoffs, if they exist, of each. We also
describe how to reach the main 

 programming menu from the given

programming location.

There are essentially three basic programming configurations. After we
look at those, we discuss a program variation.

This choice implies that at least one monitor-out line on the 

 is utilized as a local monitor and that you have a keyboard connected to the

 for programming purposes (see Figure 2-1).

(a)

Initialize the keyboard to your local monitor (see 

, 

1.0  SAT MENU PROGRAMMING)

(b)

Press the PGM key on the KBD200 or 300.*

(c)

Enter the password (default 

) and press the ACK key. This activates the main 

 programming menu.

* Although the KBD300V can be used for programming, we don’t

mention it here because (1) it can only be hooked up using the

  keyboard remote port and (2) it requires a dedicated local

monitor-out line for its LCD display. The KBD300V is discussed in
APPENDICES II and III.

PRELIMINARIES

...................................................................... 2-1

........................................ 2-5

PROGRAM MODE

Camera Programming Menu ............................................. 2-6
Monitor Programming Menu ............................................. 2-8
Time-Date Programming Menu ....................................... 2-11
Alarms Programming Menu ............................................ 2-12
Ports Programming Menu ............................................... 2-13
Auxiliaries Programming Menu ....................................... 2-14
Password Programming Menu ........................................ 2-14
Access Programming Menu ............................................ 2-15

.................................... 2-16

OPERATIONAL MODE

Presets ............................................................................ 2-16
Patterns ........................................................................... 2-17
Zones .............................................................................. 2-18

.............................. 2-19

PROGRAMMING MODE

Comms File ..................................................................... 2-19
Cameras File .................................................................. 2-20
Link Cameras File ........................................................... 2-20
Alarm File ........................................................................ 2-21

  Local control and alarm notification operations are

accessible on the 

 of the configuration. The system user

can call up link cameras. Local 

 alarms can be viewed locally

and/or automatically reported to the system user. Associated 

alarm camera displays can be placed on tie lines for viewing on
system alarm monitors (this is the primary configuration that we
use when discussing 

 configuration, operation and program-

ming). It encompasses all the elements that the 

 is designed to

use and avoids programming from the system side, which is less
efficient.

  From a system user viewpoint, local 

 op-

eration and programming means someone must be stationed at
the satellite location to fully utilize its functions. If you are interested
only in alarm notification back to the system, you have, at most,
only three tie lines available, instead of four.