Справочник Пользователя для Pelco C579M
2-20
C1510M-A (2/03)
SECTION 2
3.2 CAMERAS FILE
Close the
Comms
tab and open the
Cameras
file by clicking on its tab.
Identify the ports on the MXB to which
monitor-outs from the
monitor-outs from the
SAT
are at-
tached. Configure the
Cameras
file
accordingly.
Figure 2-7
Programming the Cameras File
Figure 2-8
Programming the Link Cameras File
3.3 LINK CAMERAS FILE
Open up the Link Cameras tab next. In
the
the
Link Cameras
file, assign unique
logical numbers for the cameras to dis-
tinguish them from non-SAT types. Ac-
cess to link cameras from CM9760-
KBDs attached to the system node use
the logical numbers just referred to, to
call the satellite camera desired. For
each line entry that that defines a link
camera, enter the PTZ port number to
which the
tinguish them from non-SAT types. Ac-
cess to link cameras from CM9760-
KBDs attached to the system node use
the logical numbers just referred to, to
call the satellite camera desired. For
each line entry that that defines a link
camera, enter the PTZ port number to
which the
SAT
for that camera is at-
tached and also enter the port address
(1-16, on the
(1-16, on the
SAT
), to which the Link
Camera is attached. An example Link
Camera file is shown to the right.
Camera file is shown to the right.