Справочник Пользователя для Pelco C1525M-B

 

C1531M

 

  October 25, 2005 

 

C1525M-B

 

The instructions provided in this section replace the steps listed on page 11 of the Installation/Operation manual for 
installing the VMX200 in a 19-inch equipment rack.

 

The instructions provided in this section replace the steps listed on page 15 of the Installation/Operation manual for 
connecting analog video inputs to the VMX200-SYS-Q.

 

The following instructions replace the steps listed on page 11 of the Installation/Operation manual for installing the VMX200 in a 19-inch equipment rack.

Refer to Figure 1 for the following instructions.

1. Attach the rack ears to the front sides of the VMX200 with the 10-32 x 0.250-inch screws.

2. Attach the brackets to the sides of the equipment with the 8-32 x 0.250-inch screws.

3. Fasten the front and rear support rails together with the 8-32 x 0.375-inch screws with lock washers.

4. Attach the support rails to the equipment rack with the 10-32 x 0.375 inch screws.

5. Slide the brackets on the equipment onto the support rails.

6. Fasten the rack ears to the equipment rack with 

the 10-32 x 0.750-inch screws and washers.

VMX200

(4) SCREWS,
10-32 X 0.750-INCH
PHILLIPS, PAN HEAD
WITH WASHERS

SLOTTED HOLES
TOWARDS FRONT
OF UNIT

TAPERED ENDS
TOWARDS REAR
OF UNIT

(6) SCREWS, 8-32 X 0.250-INCH
PAN HEAD (3 EACH SIDE)

BRACKET
(SIDE VIEW)

(4) SCREWS,
10-32 X 0.375-INCH
FLAT HEAD

(6) SCREWS,
8-32 X 0.375-INCH,
PAN HEAD WITH 
WASHERS

(8) SCREWS,
10-32 X 0.375-INCH, 
FLAT HEAD

SUPPORT RAILS

RACK

Figure 1.  Installation of Support Rails