Справочник Пользователя для Pelco C1525M-B
Worldwide Headquarters • 3500 Pelco Way • Clovis, California 93612 USA •
USA & Canada • Tel: 800/289-9100 • Fax: 800/289-9150
International • Tel: 1-559/292-1981 • Fax: 1-559/348-1120
Connecting Analog Video to the VMX200-SYS-Q
The video input card that is supplied with the VMX200-SYS-Q has changed, and now it has only four video input connectors. The original configuration
described in the VMX200 Installation/Operation manual included the yellow input connector. Now the configuration uses the black input connector instead
of the yellow.
described in the VMX200 Installation/Operation manual included the yellow input connector. Now the configuration uses the black input connector instead
of the yellow.
To connect video inputs to the VMX200-SYS-Q, complete the following steps and refer to Figure 2:
1. Connect the “spider” video input cable to the video port on the VMX200-SYS-Q rear panel.
2. Connect the four BNC connectors on the spider cable to the video source (for example, cameras or the monitor output of a switcher or multiplexer).
The spider cable contains four input connectors, coded by color. Use the BNC connectors as follows:
•
Input 1 (Red)
•
Input 2 (Green)
•
Input 3 (Blue)
•
Input 4 (Black)
NOTE:
Refer to the appropriate installation manual for each video input device for additional instructions.
Figure 2.
How to Connect Analog Video to the VMX200-SYS-Q
VMX200-SYS-Q
SPIDER
CABLE
CABLE
1
2
3
4
2
3
4
RED
GREEN
BLUE
BLACK
GREEN
BLUE
BLACK
INPUT
COLOR