Справочник Пользователя для Pelco C1973M-B

6

Pelco Manual C1973M-B (8/03)

There are three methods of installation for the MRD1400HZ16. The unit can be mounted
directly to a wall, or installed inside a dome or enclosure using the supplied mount adapters.
Refer to the following sections and select the correct installation method for your application.

To mount the MRD1400HZ16 directly to a wall, refer to Figure 2 and do the following:

1.

Select the mounting location. Install the unit close to the camera.

2.

Use the MRD1400HZ16 as a template to mark the two fastener positions onto the
mounting surface.

3.

Prepare the surface and install the fasteners. Do not tighten fasteners at this time.

4.

Align the mounting holes of the MRD1400HZ16 with the installed wall fasteners.

5.

Place the unit over the fasteners, and then slide the box down into position. Tighten
the fasteners to secure the unit to the wall.

6.

Make all required control, power, and camera connections. Refer to Figure 8 and the

Control, Power, and Camera Connections

 section of this manual.

Figure 2. Wall Mounting

To install the MRD1400HZ16 in a DF5/DF8 dome:

1.

Remove the MRD board from the MRD1400HZ16. To remove the board:

a.

Unscrew the two Phillips button head screws from the unit (refer to Figure 2), and
remove the cover. Discard the screws.

b.

Using a small screwdriver, carefully pry each corner of the board from the PEM
studs. Refer to Figure 4.

2.

Use the four 4-40 Phillips button head screws (provided) to attach the board to the
DF5/DF8/EH2512 Series adapter.

3.

Assemble the tilt table supplied with the dome. For detailed instructions refer to the
manual supplied with the DF5/DF8 Series dome.

4.

Refer to Figure 3. Attach the board to the tilt table with the supplied #10 nut and
washer.

5.

Make all required control, power, and camera connections. Refer to Figure 8 and the

Control, Power, and Camera Connections

 section of this manual.

6.

Refer to the manual supplied with the DF5 or DF8 Series dome to install the camera
and complete the installation.

Us

e only

 UL

 lis

ted

Clas

s 2 Power Sourc

e

4-40 PHILLIPS BUTTON
HEAD SCREW

TO

CAMERA

01220