Справочник Пользователя для Pelco EH3512
8
C478M-M (1/06)
9. If the enclosure has accessories that require power, you will need to access the PC board.
To remove the cover, insert a screwdriver into the slot on top of the cover and lift the cover off.
Connect the power for the accessories to pins 1 and 2 on the PC board (refer to Figures 4, 5, and
6 for information about accessory wiring). If required, connect ground to the stud on the bottom
of the enclosure just in front of the PC board.
6 for information about accessory wiring). If required, connect ground to the stud on the bottom
of the enclosure just in front of the PC board.
Replace the PC board cover, making sure it snaps securely back into place.
Figure 3.
Accessing the PC Board
10. If the camera lens is adjustable, extend the lens to its maximum length; verify that the camera
is adjusted with the lens a minimum of 1/2 inch from the enclosure window.
11. Tighten the screws that secure the sled to the enclosure.
12. Adjust the glands for a tight fit around the cables.
13. Close the enclosure lid, and latch.
14. Adjust the camera focus and iris if necessary. If you need to adjust the focus and iris manually,
open the enclosure lid, adjust the focus and iris, and close the enclosure lid.
PC BOARD COVER
PC BOARD
GROUNDING
STUD
STUD