Справочник Пользователя для Pelco FR8308

 

C1647M  (3/05)

13

 

The FT8308 transmitter/FR8308 receiver can be mounted to a wall in the following ways:

•

Using the supplied wall clip for attachment of a single module to a wall. For installation 
instructions, refer to the 

 

 section 

below.

•

Using the optional WM5002 wall mount kits, which are designed for mounting of 
double-width fiber optic modules. The WM5002-3U base kit allows attachment of a 
single module to the wall. The WM5002-3UEXP expansion kit allows attachment of an 
additional module to the wall. It is recommended that a maximum of one expansion kit 
be used with the base kit, allowing a maximum of two double-width modules to be 
attached to the wall.

 

  The WM5002 wall mount kits can be used with the WM5001 wall mount kits, 

which are designed for mounting of single-width fiber optic modules. If mounting a mix of 
single-width and double-width modules is desired, it is recommended that a maximum of 
two single-width modules and one double-width module be mounted in combination with 
one another.

For mounting instructions using the wall mount kits, refer to the WM5000 Series W all 
Mount Kit Installation manual.

 

  Before mounting the FT8308 transmitter/FR8308 receiver to a wall, ensure that 

there is adequate space at both ends for viewing the front-panel LEDs and for making 
the various rear-panel cable connections.

To attach the FT8308 transmitter/FR8308 receiver to a wall using the supplied wall clip, refer 
to Figure 6 and do the following:

1.

Using the two vertical or horizontal wall-mounting holes, attach the wall clip to a wall 
using two screws (not provided).

2.

Slide the module into the clip until the two holes on the bottom of the module align with 
the two holes on the lower flange of the clip.

3.

Attach the module to the clip using the two Phillips pan head screws provided for the clip.