Справочник Пользователя для Chamberlain security hd200dm

30

Your Security

✚

®

 opener and hand-held remote control 

have been factory-set to a matching code which changes 
with each use, randomly accessing over 100 billion new 
codes. Your opener will operate with up to eight Security

✚

®

 

remote controls and one Security

✚

®

 Keyless Entry System. 

If you purchase a new remote, or if you wish to deactivate 
any remote, follow the instructions in the Programming 
section. 

Activate your opener with any of the following:
•   The hand-held Remote Control: Hold the large push 

button down until the door starts to move.

•   The wall-mounted Door Control: Hold the push button or 

bar down until the door starts to move.

•   The Keyless Entry (See Accessories): If provided with 

your garage door opener, it must be programmed before 
use. See Programming.

When the opener is activated (with the safety reversing 
sensor correctly installed and aligned)
1.  If open, the door will close. If closed, it will open.
2.  If closing, the door will reverse.
3.  If opening, the door will stop.

4.  If the door has been stopped in a partially open position, 

it will close.

5.  If obstructed while closing, the door will reverse. If the 

obstruction interrupts the sensor beam, the opener lights 
will blink for five seconds.

6.  If obstructed while opening, the door will stop.
7.  If fully open, the door will not close when the beam is 

broken. The sensor has no effect in the opening cycle.

If the sensor is not installed, or is misaligned, the door 
won't close from a hand-held remote. However, you can 
close the door with the Door Control, the Outside Keylock, 
or Keyless Entry, if you activate them until down travel is 
complete. If you release them too soon, the door will 
reverse. 

The opener light will turn on under the following 
conditions: when the opener is initially plugged in; when 
power is restored after interruption; when the opener is 
activated. 

Light will also turn on when someone walks through the 
open garage door.

They will turn off automatically after 4-1/2 minutes. Bulb 
size is A19. Bulb power is  100 watts maximum.

1.   READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS.
2.   ALWAYS keep remote controls out of reach of children. 

NEVER permit children to operate or play with garage door 
control push buttons or remote controls. 

3.   ONLY activate garage door when it can be seen clearly, it is 

properly adjusted, and there are no obstructions to door 
travel.

4.   ALWAYS keep garage door in sight until completely closed. 

NO ONE SHOULD CROSS THE PATH OF THE MOVING 
DOOR.

5.   NO ONE SHOULD GO UNDER A STOPPED, PARTIALLY 

OPENED DOOR.

6.   If possible, use emergency release handle to disengage 

trolley ONLY when garage door is CLOSED. Weak or broken 
springs or unbalanced door could result in an open door 
falling rapidly and/or unexpectedly.

7.   NEVER use emergency release handle unless garage 

doorway is clear of persons and obstructions.

8.   NEVER use handle to pull garage door open or closed. If 

rope knot becomes untied, you could fall.

  9.   If one control (force or travel limits) is adjusted, the other 

control may also need adjustment.

10.   After ANY adjustments are made, the safety reversal 

system MUST be tested.

11.   Safety reversal system MUST be tested every month. 

Garage door must reverse on contact with 1-1/2" high 
(3.8 cm) object (or a 2x4 laid flat) on the floor.

12.   ALWAYS KEEP GARAGE DOOR PROPERLY BALANCED 

(see page 3). An improperly balanced door may not 
reverse when required and could result in SEVERE INJURY 
or DEATH.

13.   ALL repairs to cables, spring assemblies and other 

hardware, ALL of which are under EXTREME tension, 
MUST be made by a trained door systems technician.

14.   ALWAYS disconnect electric power to garage door opener 

BEFORE making ANY repairs or removing covers.

15.