Справочник Пользователя для Dukane 403-575-00

 - Operate system components only 

after they are properly installed.

- Do not modify your 

system in any way unless authorized to do so by Dukane 

Corporation.  Unauthorized  modifications  could  cause 

equipment damage and/or injury to the operator. In ad-

dition, unauthorized modifications will void equipment 

warranty.

 - Do not remove any equipment 

cover unless directed to do so by Dukane Corporation. The 

generator produces hazardous electrical voltages which 

could cause injury.

- Operate this equipment 

only with a grounded electrical connection.

See Electrical Safety for grounding instructions, Page 9.

- You may be required to add 

accessories to bring the system into compliance with 

applicable regulations (OSHA in the USA) for machine 

guarding and noise exposure.

 - Wear ANSI approved safety impact 

goggles.

 - When an acoustic stack (trans-

ducer, booster, horn and tip) is energized by the ultrasound 

signal, it presents a potential hazard. Stay clear of an 

energized stack.

 - Install a system abort switch at 

each operator station when ultrasonic plastic assembly 

equipment is used with automatic material handling equip-

ment in an automated system.

 - Using a foot switch in place of the optical 

touch finger switches (activation switches) violates OSHA 

regulations.

These recommendations apply to the 

welding system. System in this manual 

refers to a complete group of components 

associated with the welding of parts, also 

known as an ultrasonic assembly system. 

A typical iQ Series System consists of 

the iQ generator, a press with thruster, 

switches, controls, cables, transducer, 

booster, horn, and fixture, 

and iQ Explorer 

software

.                                            

At some time you may be asked to 

remove equipment covers by the 

Dukane Service Dept. personnel. 

Before doing so, disconnect the 

unit electrically from the incoming line AC 

power. If the unit is a press/thruster, lock the 

Air Lockout Valve, located on the rear panel, 

in its closed position.

Please observe these health and safety recommenda-

 for safe, efficient, and injury-free operation of your 

equipment.

