Справочник Пользователя для Intermatic ig1300 installation
STEP 19
Close the cover on the IG1300.
Close the cover on the IG1300.
SPECIAL INSTRUCTIONS
Use the following steps when installation requires placing the IG1300 on the
left side of the electrical panel.
STEP A
Loosen the screw in hole C that secures the coaxial cable protection
module(s) to the wire channel cover. Remove the coaxial modules and set
them to one side for future use. Remove screw C completely.
STEP B
Invert the wire channel cover with the telephone line protection modules still
attached to it and place it into
the IG1300 cabinet as shown
in Figure 4. Install a Torx
screw through the hole in the
foot of the wire channel cover
and into hole E and tighten it
snugly to the back of the cabi-
net.
STEP C
Insert a Torx screw through
the elongated hole on the
coaxial protection module(s)
and into hole D as shown in
Figure 4. Do not tighten the
screw.
STEP D
Place the remaining Torx
screw through the opening on
the tab of the coaxial protec-
tion module(s) and into hole F.
Tighten the Torx screws firmly
to ensure a good ground
bond.
NOTE:
If the telephone protection Modules are left in an inverted position as shown in
figure 4, be sure to observe the “IN” and “OUT” markings.
STEP E
Return to Step 12.
Use the following steps when installation requires placing the IG1300 on the
left side of the electrical panel.
STEP A
Loosen the screw in hole C that secures the coaxial cable protection
module(s) to the wire channel cover. Remove the coaxial modules and set
them to one side for future use. Remove screw C completely.
STEP B
Invert the wire channel cover with the telephone line protection modules still
attached to it and place it into
the IG1300 cabinet as shown
in Figure 4. Install a Torx
screw through the hole in the
foot of the wire channel cover
and into hole E and tighten it
snugly to the back of the cabi-
net.
STEP C
Insert a Torx screw through
the elongated hole on the
coaxial protection module(s)
and into hole D as shown in
Figure 4. Do not tighten the
screw.
STEP D
Place the remaining Torx
screw through the opening on
the tab of the coaxial protec-
tion module(s) and into hole F.
Tighten the Torx screws firmly
to ensure a good ground
bond.
NOTE:
If the telephone protection Modules are left in an inverted position as shown in
figure 4, be sure to observe the “IN” and “OUT” markings.
STEP E
Return to Step 12.
Figure 4
5
Torx T-20
in Hole E
in Hole E
Torx T-20
in Hole D
in Hole D
Torx T-20
in Hole F
in Hole F
TROUBLESHOOTING and ASSISTANCE:
Technical Services 815-675-7000
http://www.intermatic.com