Справочник Пользователя для Metra Electronics 99-5500

TOOLS REQUIRED

Cutting tool

Phillips screwdriver

KIT COMPONENTS

Radio Housing

Bracket
Set #1

APPLICATIONS

FORD/MERCURY 1979-91
(SEE INSIDE FOR SPECIFIC APPLICATIONS)

99-5500

INSTALLATION
INSTRUCTIONS

ALL VEHICLES

Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).

Re-connect the battery terminal and test the unit
for proper operation. Mount the radio/kit
assembly to the sub-dash with those screws
previously removed in step #1.

A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape

2-SHAFT HEAD UNITS: Attach the Shaft Masks to the Radio Housing. Slide the
aftermarket head unit into the kit and secure with shaft nuts. (see Fig. A)

DIN HEAD UNITS: Using the scored lines on the back of the Radio Housing as a guide, cut
and remove the shaft supports. Slide the DIN cage into the kit and secure by bending the metal
locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. B)

Fig. A

Fig. B

Bracket
Set #4

Bracket
Set #5

Bracket
Set #2

Bracket
Set #3

Bracket #6

Bracket
Set #7

(4) Nuts

(4) 3/8" Phillips
Flat-head Screws

(4) #8 x ¾"
Hex-head Screws

1-800-221-0932 www.metraonline.com

rev. 030701