Справочник Пользователя для Hitachi p13f

— 17 —

Snipe
(gouging at ends of
board)

Fuzzy grain

Torn grain

Rough raised grain

Uneven depth of cut
(side to side)
Rollercase elevation
adjusts with difficulty

Board feeds inside, but
stops moving past the
outfeed roller

Board thickness does
not match depth of cut
scale
Chain jumping

Planer will not operate

Belt slipping
Rollercase connot be
lowered

1. Dull blades.

2. Inadequate support of long boards.

3. Uneven force on cutterhead.

4. Rollercase not level with base.

5. Lumber not butted properly.

Planing wood with a high moisture

content

1. Too heavy a cut

2. Blades cutting against grain

3. Dull blades

1. Dull blades

2. Too heavy a cut

3. Moisture content too high

Rollercase not level with Planer

1. Gears dirty

2. Elevation screws dirty

3. Gears, elevation screws worn

4. Friction between rollercase and covers

5. Rollercase not parallel with planer base

6. Rollercase lock engaged

1. Outfeed rollers cannot rotate due

to

clogging of chips

2. Too much pressure on the

cutterhead from long workpiece

Indicator not set correctly

1. Sprockets worn

2. Chain worn

1. No power to planer

2. Motor overload protection

tripped

3. Defective or loose switch or

wiring.

Loose belt

Workpiece thickness gauge setting

restricts rollercase movement.

1. Replace blades per instructions.

See CHANGING THE BLADE.

2. Support long boards. See Avoiding Snipe.

3. Gently push board when board is in contact

with only one feed roller. See Avoiding

Snipe.

4. Adjust rollercase. See Adjusting.

5. Butt each piece of stock end-to-end as

boards pass through planer.

Remove high moisture content from wood

by drying

1. Review OPERATION.

2. Review OPERATION.

3. Replace blades per instructions. See

CHANGING THE BLADES.

1. Replace blades per instructions. See

CHANGING THE BLADES.

2. Review OPERATION.

3. Dry the wood or use dried wood.

Rollercase not level. See ADJUSTING.

1. Clean and lubricate gears.

2. Clean and lubricate elevation screws.

3. Replace gears, elevation screw.

4. Clean and lubricate.

5. Adjust rollercase. See ADJUSTING.

6. Release rollercase lock

1. Clear the clogging, use dust collector chip

chute.

 2. Use support stands to support workpiece

longer than 24”.

Adjust indicator and tighten securely.

1. Replace sprockets.

2. Replace chain.

1. Check power source by qualified electrician.

2. Turn planer off. Reset motor overload

protection.

3. Check switch and wiring by qualified

electrician.

Replace belt, see Replacing V-Belt.

Reset thickness gauge setting.

To avoid injury from an accidental start-up, always turn switch OFF and unplug the planer before moving, replacing the
blade or making adjustments.