Справочник Пользователя для KVH Industries kvhtracvision g4
2.6
Wiring the ADCU
All other wiring for the TracVision system connects at the rear
panel of the ADCU. Included in the GyroTrac kitpack are five
terminal strip connectors with terminal connectors numbered 1
through 60 (see Figure 2-20). You will connect all wires to these
terminal strip connectors first, then you will insert the connectors
into the rear panel of the ADCU.
panel of the ADCU. Included in the GyroTrac kitpack are five
terminal strip connectors with terminal connectors numbered 1
through 60 (see Figure 2-20). You will connect all wires to these
terminal strip connectors first, then you will insert the connectors
into the rear panel of the ADCU.
For the TracVision system to work, you must wire the following
cables to the ADCU:
cables to the ADCU:
•
Antenna Data Cable
•
Antenna Power Cable (unless you are connecting
antenna power to its own circuit)
antenna power to its own circuit)
•
GyroTrac Sensor Cable
•
Vessel Power Cable
•
IRD Ground Cable(s)
You may also connect other external devices, such as an
autopilot, plotter, remote display, or GPS, to the ADCU.
autopilot, plotter, remote display, or GPS, to the ADCU.
Figure 2-21 on the following page shows all available connections
to the ADCU.
to the ADCU.
Installation
54-0147
29
25
33
32
31
30
29
28
27
26
36
35
34
1
9
8
7
6
5
4
3
2
12
11
10
13
21
20
19
18
17
16
15
14
24
23
22
60
52
53
54
55
56
57
58
59
49
50
51
48
40
41
42
43
44
45
46
47
37
38
39
Green Label
Blue Label
White Label
Red Label
Yellow Label
Figure 2-20
Terminal Strip Connectors
Connect all wires to the terminal
strip connectors first. DO NOT
attach the terminal strip connectors
to the ADCU until you have
completed and verified all wiring.
strip connectors first. DO NOT
attach the terminal strip connectors
to the ADCU until you have
completed and verified all wiring.