Справочник Пользователя для National Instruments NI 9219
© National Instruments Corp.
9
NI 9219 Operating Instructions
Connecting Wires to the NI 9219 Connectors
Use a flathead screwdriver with a blade smaller than 2.3 × 1.0 mm
(0.09 × 0.04 in.) to connect wires to the detachable spring-terminal
connectors. Insert the screwdriver into a spring clamp activation
slot and press a wire into the corresponding connector terminal,
then remove the screwdriver to clamp the wire into the terminal.
Refer to the
(0.09 × 0.04 in.) to connect wires to the detachable spring-terminal
connectors. Insert the screwdriver into a spring clamp activation
slot and press a wire into the corresponding connector terminal,
then remove the screwdriver to clamp the wire into the terminal.
Refer to the
section for more information about
spring-terminal wiring. Refer to Figure 2 for an illustration of
connecting wires to the NI 9219.
connecting wires to the NI 9219.
Figure 2. Connecting Wires to the NI 9219 Connectors