Справочник Пользователя для Hoyt recurve-2006
9
7. Reassembly is accomplished by inserting the dowel into the
sight window side of the riser, and aligning the dowel radially as
shown in the figures on page 8. Then, snugly lock the radial set
screw to pin the dowel in place. Re-install any leftover washers
and the alignment cap, then using the two supplied Allen
wrenches; complete the reassembly by re-installing the dowel
cap washer and lock screw. Tighten snugly.
8. Re-check all locking screws for tightness and reassemble the
bow.
sight window side of the riser, and aligning the dowel radially as
shown in the figures on page 8. Then, snugly lock the radial set
screw to pin the dowel in place. Re-install any leftover washers
and the alignment cap, then using the two supplied Allen
wrenches; complete the reassembly by re-installing the dowel
cap washer and lock screw. Tighten snugly.
8. Re-check all locking screws for tightness and reassemble the
bow.
AeroTec & Matrix Alignment:
Follow the same directions as given for the Helix, omitting the
steps concerning the Helix radial locking screw (steps 5-8). Be
sure to mark the dowel radial position before making adjust-
ments.
Follow the same directions as given for the Helix, omitting the
steps concerning the Helix radial locking screw (steps 5-8). Be
sure to mark the dowel radial position before making adjust-
ments.
Eclipse Alignment:
Tiller and weight adjustments for the Eclipse follow the same
directions as those for the Helix, AeroTec and Matrix. The
Hardlock dovetail limb mounting system on the Eclipse is facto-
ry preset and is not user adjustable.
Tiller and weight adjustments for the Eclipse follow the same
directions as those for the Helix, AeroTec and Matrix. The
Hardlock dovetail limb mounting system on the Eclipse is facto-
ry preset and is not user adjustable.
Gold Medalist Alignment:
The Gold Medalist uses a simple system for weight and tiller
adjustment. GM risers have 8-10% of weight adjustability,
depending upon limb length, limb design, and brace height.
The Gold Medalist uses a simple system for weight and tiller
adjustment. GM risers have 8-10% of weight adjustability,
depending upon limb length, limb design, and brace height.
To adjust bow weight on a GM, first unstring the bow with a bow
stringer and remove the limbs. Locate the weight set locking
screw
stringer and remove the limbs. Locate the weight set locking
screw
and
completely
remove this screw from the
riser. This will expose the
adjustment screw (non-
removable). To increase bow
weight rotate this screw
riser. This will expose the
adjustment screw (non-
removable). To increase bow
weight rotate this screw
Locking Screw