Справочник Пользователя для Crestron av2 pro2

2-Series Integrated Dual Bus Control System 

 

Crestron AV2 & PRO2

Crestron recommends using the latest programming software and that each device 
contains the latest firmware to take advantage of the most recently released features.  
However, before attempting to upload or upgrade, it is necessary to establish 
communication.  

While the next section provides an overview for communication, refer to 
“Establishing Communications with the Control System” in the Crestron 2-Series 
Control System Reference Guide (Doc. 6256) for serial and TCP/IP connection 
details. If communications cannot be established, refer to “Troubleshooting 
Communications” in the same guide. 

Use Crestron Toolbox for communicating with the AV2 & PRO2; refer to the 
Crestron Toolbox help file for details. There are two methods of communication. 

Direct Serial Communication    NOTE:  Required for initial setup of Ethernet parameters. 

PC RUNNING

CRESTRON TOOLBOX

AV2 or PRO2

SERIAL VIA CRESTRON

CABLE STCP-502PC

OR EQUIVALENT

 

•  The COMPUTER port on the AV2 & PRO2 connects to the serial port on 

the PC via a serial cable (Crestron STCP-502PC or equivalent).  

•  Use the Address Book in Crestron Toolbox to create an entry using the 

expected serial communication protocol (RS232, auto-detect baud rate, no 
parity, 8 data bits, 1 stop bit, XON/XOFF disabled, RTS/CTS enabled). 

•  Display the AV2’s or PRO2’s “System Info” window (click the 

 icon); 

communications are confirmed when the device information is displayed. 

PC RUNNING

CRESTRON TOOLBOX

AV2 or PRO2

ETHERNET

 

•  Establish direct serial communication between AV2 or PRO2 and PC. 
•  Enter the IP address, IP mask, and default router of the AV2 or PRO2 via 

the Crestron Toolbox (Functions | Ethernet Addressing); otherwise enable 
DHCP. 

•  Confirm Ethernet connections between AV2 or PRO2 and PC. If connecting 

through a hub or router, use CAT5 straight through cables with 8-pin RJ-45 
connectors. Alternatively, use a CAT5 crossover cable to connect the two 
LAN ports directly, without using a hub or router. 

•  2-Series Integrated Dual Bus Control System: AV2 & PRO2