Справочник Пользователя для Cadillac catera 2001

Your vehicle’s engine should be turned off but the
ignition must be ON (II) while programming the
transmitter. Follow these steps to program up to 
three channels:

1. If you have previously programmed a transmitter

channel, proceed to Step 2. Otherwise, hold down
the two outside buttons on the HomeLink transmitter
until the indicator light begins to flash rapidly 
(after 20 seconds). Then release the buttons. 
This procedure initializes the memory and erases any
previous settings for all three channels.

2. Decide which one of the three channels you want to

program. Hold the end of the hand

-

held transmitter

about 2 to 5 inches (5 to 13 cm) away from the
surface of the HomeLink transmitter so that you can
still see the indicator light.

3. Using both hands, press the hand

-

held transmitter

button and the desired button on the HomeLink
transmitter. Continue to press both buttons 
through Step 4.

4. Hold down both buttons until you see the indicator

light on the HomeLink transmitter flash slowly and
then rapidly. The rapid flashing indicates that the
HomeLink transmitter has been programmed.
Release both buttons once the indicator light starts 
to flash rapidly.

Your Catera may be equipped with a metallic

-

coated,

heat reflective windshield to help keep your vehicle
cool. If you experience difficulty when using your
remote control transmitter be sure you have followed the
directions exactly, and that you are pointing the device
through the top center of the windshield in the black
dotted area. Any usage of devices other than in this area
may cause malfunctions to occur. Also, the HomeLink
transmitter may not work with older garage door
openers that do not meet current Federal Consumer
Safety Standards. If you cannot program the transmitter
after repeated attempts, refer to “Rolling Code
Programming” later in this section or contact the
HomeLink transmitter manufacturer at 1

-

800

-

355

-

3515.

Be sure to keep the original hand

-

held transmitter 

in case you need to erase and reprogram the 
HomeLink transmitter.

Canadian Owners: During programming, the
hand

-

held transmitter may automatically stop

transmitting after one or two seconds. In this case, you
should press and re

-

press the button on the hand

-

held

transmitter every two seconds without ever releasing the
button on the HomeLink transmitter. Release both
buttons when the indicator light on the HomeLink
transmitter begins to flash rapidly.