Справочник Пользователя для National Instruments pci-6110e-6111e
Chapter 4
Signal Connections
4-30
©
National Instruments Corporation
Figure 4-26 shows the timing requirements for the GPCTR0_SOURCE
signal.
signal.
Figure 4-26. GPCTR0_SOURCE Signal Timing
The maximum allowed frequency is 20 MHz, with a minimum pulse
width of 10 ns high or low. There is no minimum frequency limitation.
width of 10 ns high or low. There is no minimum frequency limitation.
The 20 MHz or 100 kHz timebase normally generates the
GPCTR0_SOURCE signal unless you select some external source.
GPCTR0_SOURCE signal unless you select some external source.
GPCTR0_GATE Signal
Any PFI pin can externally input the GPCTR0_GATE signal, which is
available as an output on the PFI9/GPCTR0_GATE pin.
available as an output on the PFI9/GPCTR0_GATE pin.
As an input, the GPCTR0_GATE signal is configured in the
edge-detection mode. You can select any PFI pin as the source for
GPCTR0_GATE and configure the polarity selection for either rising or
falling edge. You can use the gate signal in a variety of different
applications to perform actions such as starting and stopping the
counter, generating interrupts, saving the counter contents, and so on.
edge-detection mode. You can select any PFI pin as the source for
GPCTR0_GATE and configure the polarity selection for either rising or
falling edge. You can use the gate signal in a variety of different
applications to perform actions such as starting and stopping the
counter, generating interrupts, saving the counter contents, and so on.
As an output, the GPCTR0_GATE signal reflects the actual gate signal
connected to general-purpose counter 0. This is true even if the gate is
being externally generated by another PFI. This output is set to tri-state
at startup.
connected to general-purpose counter 0. This is true even if the gate is
being externally generated by another PFI. This output is set to tri-state
at startup.
t
p
t
w
t
w
t
p
t
w
= 50 ns minimum
= 10 ns minimum
PCI_E.book Page 30 Thursday, June 25, 1998 12:55 PM