Справочник Пользователя для National Instruments FP-3000
Chapter 2
Installation and Configuration
2-8
©
National Instruments Corporation
connectors should remain firmly mated after all the bases are mounted
to the panel.
to the panel.
5.
Place the protective cover (from the bag of accessories that came with
your FP-3000) onto the local bus connector of the last terminal base on
the bank.
your FP-3000) onto the local bus connector of the last terminal base on
the bank.
Removing the FP-3000 and Terminal Bases from
the Panel
the Panel
To remove an FP-3000 network module and terminal bases from the panel,
reverse the process described in the previous sections,
reverse the process described in the previous sections,
.
First remove the terminal bases, starting with the last one, then remove the
network module.
network module.
Mount I/O Modules onto Terminal Bases
Follow these steps to connect an I/O module to a terminal base:
1.
Position the first module with its alignment slots aligned with the guide
rails on the terminal base, as shown in Figure 2-9.
rails on the terminal base, as shown in Figure 2-9.
2.
Firmly press the module onto the terminal base. The terminal base
latch locks the I/O module into place.
latch locks the I/O module into place.
3.
Repeat this procedure to install additional I/O modules onto terminal
bases.
bases.
Figure 2-9. Mounting I/O Module to Terminal Base
Alignment Slot
Key
Latch
Guide Rail
Guide Rail
Terminal Base
I/O Module