Справочник Пользователя для Fujitsu ScanSnap S510M

ScanSnap S510M Getting Started

 

30

This chapter describes how to clean the ScanSnap.

*1) It may take long before the cleaner vaporizes if a large quantity is used. When cleaning the ScanSnap 

parts, dampen a cloth with modest quantities of the cleaner. In addition, wipe off the cleaner 
completely with a soft lint-free cloth to leave no residue on the surface of the cleaned parts.

*2) Pre-moistened with Cleaner F1, Cleaning Wipes are used instead of moistened cloths.
*3) Any lint-free cloth can be used.

To purchase the cleaning material, contact the store where you purchased the ScanSnap or an authorized 
FUJITSU scanner service provider.

Clean the ScanSnap exterior with a cloth moistened with a small amount of neutral detergent or Cleaner 
F1 (sold separately).

• Before you clean the ScanSnap, unplug the power cable from the power outlet to 

prevent from fire or electric shock.

• To avoid injuries, do not place the internal parts (such as the Pad ASSY and pick roller) 

in areas where small children can reach.

• Do not use any aerosol sprays or alcohol based sprays to clean the ScanSnap. Dust 

blown up by strong air from the spray may enter the inside of the ScanSnap. This may 
cause the ScanSnap to fail or malfunction. Sparks, caused by static electricity, 
generated when blowing off dust and dirt from the outside of the ScanSnap may cause 
a fire.

Cleaner F1

PA03950-0352

1 bottle (100 ml) (*1)

Cleaning wipe

PA03950-0419

1 pack (24 sheets) (*2)

Lint-free dry cloth

Commercially available. (*3)

ATTENTION

• Never use paint thinner or other organic solvents.
• During the cleaning, prevent water or moisture from getting inside the ScanSnap.

Cloth

Cleaner F1 or 

neutral detergent

Paint thinner