Справочник Пользователя для Frigidaire ftw3014kw

5

Excessive noise and vibration can be prevented by properly 
leveling the washer.

With the washer within 4 feet (1 m) of its fi nal location, 

1. 

place a level on top of the washer. 

Use adjustable pliers to adjust the leveling legs so the 

2. 

washer is level front-to-rear and side-to-side, and stable 
corner-to-corner.

Press down on alternate corners and sides and feel for the 

3. 

slightest movement. Adjust the appropriate leg(s) so the 
washer sits solidly on the fl oor on ALL four legs. Keep the 
leveling leg extension at a minimum for best performance 
of the washer.

Run some water from the hot and cold faucets to fl ush the 

1. 

water lines and remove particles that might clog the water 
valve screens and to determine which faucet is hot and 
which is cold supply.

Remove the inlet hoses and rubber washers from the 

2. 

plastic bag located in the drum of the washer and install 
the rubber washers in each end of the inlet hoses.

Connect the 

3. 

HOT inlet hose to the HOT inlet connection 

on the washer and the COLD inlet hose to the COLD 
inlet connection on the washer. Tighten by hand until 
snug. Then tighten each supply connection another 2/3 
turn with pliers. Do not cross thread or over-tighten these 
connections.

Connect the 

4. 

HOT inlet hose to the HOT water supply and 

the COLD inlet hose to the COLD water supply. Tighten 
by hand until snug. Then tighten each supply connection 
another 2/3 turn with pliers.

Turn on the water and check for leaks.

5. 

RUBBER WASHERS

MUST BE PRESENT