Справочник Пользователя для briggs--stratton 355z

www.simplicitymfg.com | www.snapper.com

 1.  Warm the engine by running for a few minutes. 

(Refer to the engine operator’s manual for oil & 
filter replacement instructions)

 2.  The oil drain hose (A, Figure 26) is located on 

the left side of the engine.  Remove the oil drain 
hose from its storage position and re-position the 
oil drain hose over the side of the engine deck 
and place a small pan beneath it to catch the old 
engine oil.

 3.  Using the appropriate tools, remove the cap (C) 

from the oil drain tube. 

 4.  After draining, replace the cap and wipe up any 

spilled oil.  Reinstall the oil drain hose into the 
storage position (route around to the front of the 
engine) to retain the hose during normal operation.

 5.  Place an absorbent shop cloth under the engine oil 

filter (B).  Remove the oil filter and discard.

 6.  Using a drop of oil (see the engine operator’s 

manual for oil recommendations) on your finger 
tip, wet the rubber gasket on the bottom of the new 
filter.

 7.  Turn the filter clockwise until the rubber gasket 

meets the filter base. Then turn 1/2” to 3/4” of a 
turn more.

 8.  Add engine oil (Refer to the engine operator’s 

manual for oil filling instructions.)

 9.  Remove the shop cloth and wipe up any spilled oil.

Refer to engine owner’s manual for all engine 
maintenance procedures and recommendations.

Inspect the muffler for cracks, corrosion, or other 
damage.  Remove the spark arrester, if equipped, 
and inspect for damage or carbon blockage.  If 
replacement parts are required, make sure to use only 
original equipment replacement parts.

Regular Maintenance

Not 

for  

Reproduction