Справочник Пользователя для briggs--stratton 355z

Oil Type:  20W-50 conventional detergent motor oil. 

 1.  Check the oil level when the unit is cold.  Raise the 

seat plate to gain access to the transmission oil 
reservoirs (A, Figure 27).  The oil should be up to 
the “FULL COLD” mark (B).  If the oil is below this 
level, proceed to step 2.  

 2.  Before removing the reservoir cap, make sure 

the area around the reservoir cap and fill neck of 
the reservoir is free of dust, dirt, or other debris.  
Remove the reservoir cap.  

 3.  Add oil up to the “FULL COLD” mark (B, Figure 

27).  

 4.  Reinstall the reservoir cap.

Change Interval: Every 200 Hours

 1.  Locate the transmission oil filters (A, Figure 

28) underneath the rear of the machine on the 
transmissions.

 2.  Remove the three 1/4” filter guard screws (C) and 

the filter guard (B).

 3.  Clean the area around the filter base and remove 

the filter.

 4.  Apply a film of new oil to the gasket of the new 

replacement filter.  After the oil has drained, thread 
the new filter onto the filter base until the gasket 
makes contact, then tighten 3/4 of a turn more.

 5.  Reinstall the filter guard with the three 1/4” filter 

guard screws

 6.  Using a hex bit swivel socket or a modified 

allen wrench remove the top port plug from the 
transmissions. 

 7.  Remove the transmission reservoir cap and 

fill with oil until oil appears at the bottom of the 
transmission’s top port (approximately 2 qts 
(1,89L).

 8.  Reinstall the top port plug and tighten to 15 ft lbs 

(20,38 Nm).

 9.  Continue to add oil to the transmission oil 

reservoirs until the oil level reaches the “FULL 
COLD” mark. Reinstall the oil reservoir cap.

 10. Repeat this process for the other side of the 

machine.

 11. Run the unit for several minutes and check the 

transmission oil level.  

Regular Maintenance

Not 

for  

Reproduction