Справочник Пользователя для briggs--stratton 355z

www.simplicitymfg.com | www.snapper.com

Troubleshooting, Adjustments, & Service

The seat and ground speed control levers should be 
adjusted so that operator’s elbows are supported by 
the arm rests when his/her hands are on the controls, 
and the ground speed control levers can be moved 
through their full range of motion without contacting 
the operator’s legs.

The seat can be adjusted forward and back.  Move 
the adjustment lever (A, Figure 30) towards the left 
hand side of the machine, slide the seat to the desired 
position, and release the lever.

The control levers can be adjusted in three ways. The 
alignment of the control levers, the placement of the 
levers (how close the ends are to one another) and 
the height of the levers can be adjusted.  

To Adjust the Handle Alignment: Loosen the mount 
bolts (A, Figure 31) and pivot the lever(s) (C) to align 
with each other.

To Adjust the Handle Placement: Loosen the jam 
nuts and adjust the placement bolt (B, Figure 31) in or 
out to properly adjust the lever end spacing.

To Adjust the Handle Height: Remove the mounting 
hardware and reposition the handle either up or down 
from its original position.  You will need to readjust the 
handle alignment as described above.

Not 

for  

Reproduction