Справочник Пользователя для briggs--stratton 355z

The cutting height adjustment pin (A, Figure 33) 
controls the mower cutting height.  The cutting height 
is adjustable between 1-1/2” (3,8 cm) and 4-1/2” 
(11,4cm).  Pulling the lever back fully locks the control 
in transport position.

To adjust cutting height:

 1.  Pull the adjustment lever (B) back fully until it locks 

in transport position. 

 2.  Remove the cutting height adjustment pin (A) and 

insert it into the desired hole.

 3.  Pull back on the adjustment lever (B), squeeze the 

smaller transport release lever (C), and allow the 
lever to move forward until it is supported by the 
cutting height adjustment pin (A).

If the unit creeps forward or backward with the control 
levers in their neutral positions, see your dealer.

If the rider veers to the right or left when the ground 
speed control levers are in the maximum forward or 
reverse position, the top speed of each of these levers 
can be balanced by turning the adjustment bolt(s) (A 
& C, Figure 32).  Only adjust the speed of the wheel 
that is traveling faster.

 1.  Loosen the jam nut securing the top speed 

adjustment bolt (A, C).

 2.  Turn the top speed adjustment bolt COUNTER-

CLOCKWISE to reduce the speed.

 3.  Retighten the securing nut when adjustment is 

complete.

Troubleshooting, Adjustments, & Service

Not 

for  

Reproduction