Справочник Пользователя для Zebra 49834
350
170PAX4 Maintenance Manual
57518L-001 Rev. 1
3/18/05
Data Ports
Applicator Interface Connector
Applicator Interface Connector Pin Configuration
The Applicator Interface Assembly is available in two versions: a +5 V I/O and a
+24 V (24–28 V) I/O.
+24 V (24–28 V) I/O.
lists the pin configurations and functions of the applicator
interface connector for both +5 V and 24–28 V operation.
Table 46 • Applicator Interface Connector Pin Configuration
Pin No.
Signal Name
Signal Type
Description
1*
I/O SIGNAL
GROUND
GROUND
(+5V Return)
I/O Signal
Ground
Ground
Using jumper J5, this pin can be configured as isolated
or non-isolated from the Applicator Interface Circuit
Ground. See
or non-isolated from the Applicator Interface Circuit
Ground. See
for more information.
1*
I/O SIGNAL
GROUND
GROUND
(+24-28V Return)
I/O Signal
Ground
Ground
Isolated I/O operation only. No jumpers to configure.
Customer must provide this external power.
Customer must provide this external power.
2*
+5V I/O
(Fused at 1 A)
Caution • Replace
the fuse only with
one of the same
type and rating.
the fuse only with
one of the same
type and rating.
Power
See
Using jumper J4, this pin can be configured as isolated
or non-isolated from the Applicator Interface Circuit
+5 V Supply. See
or non-isolated from the Applicator Interface Circuit
+5 V Supply. See
for more
information.
2*
+24-28V I/O
(Fused at 1 A)
Caution • Replace
the fuse only with
one of the same
type and rating.
the fuse only with
one of the same
type and rating.
Power
Isolated I/O operation only. No jumpers to configure.
Customer must provide this external power.
Customer must provide this external power.
3
START PRINT
Input
See
for more
information about the start and end print signals.
• Pulse Mode—The label printing process begins on
the HIGH to LOW transition of this signal if a format
is ready. Deassert this signal HIGH to inhibit printing
of a new label.
is ready. Deassert this signal HIGH to inhibit printing
of a new label.
• Level Mode—Assert LOW to enable the print engine
to begin printing if a format is ready. The print engine
prints new labels as long as the signal is asserted.
When deasserted, the currently printing label is
completed and the print engine stops and waits for this
input to be reasserted LOW.
prints new labels as long as the signal is asserted.
When deasserted, the currently printing label is
completed and the print engine stops and waits for this
input to be reasserted LOW.
4
FEED
Input
When the print engine is idle or has been paused, assert
this input LOW to trigger repeated feeding of blank
labels. Deassert HIGH to stop feeding blank labels and
register to the top of the next label.
this input LOW to trigger repeated feeding of blank
labels. Deassert HIGH to stop feeding blank labels and
register to the top of the next label.
* Applicator boards have separate part numbers for the +5V version (57056M) and the +24-28V version (57389M).