Справочник Пользователя для National Instruments cFP-RTD-124

The FP-RTD-124 mounts on a FieldPoint terminal base (FP-TB-x). 
Hot plug-and-play enables you to install the FP-RTD-124 onto a 
powered terminal base without disturbing the operation of other 
modules or terminal bases. The FP-RTD-124 receives operating 
power from the terminal base. 

To install the FP-RTD-124, refer to Figure 1 and complete the 
following steps:

1. Slide the terminal base key to either position X, used for any 

module, or position 1, used for the FP-RTD-124 module.

2. Align the FP-RTD-124 alignment slots with the guide rails on 

the terminal base.

3. Press firmly to seat the FP-RTD-124 on the terminal base. 

When the module is firmly seated, the terminal base latch locks 
it into place.

Figure 1.  Installing the FP-RTD-124

The cFP-RTD-124

 

mounts on a Compact FieldPoint backplane 

(cFP-BP-x). Hot plug-and-play enables you to install the 
cFP-RTD-124 onto a powered backplane without disturbing the 
operation of other modules or connector blocks. The cFP-RTD-124 
receives operating power from the backplane.

Alignment

Slot

Key

Latch

Guide Rails

Terminal Base

I/O Module