Справочник Пользователя для National Instruments NI CardBus-8310-to-PXI Expansion

© National Instruments Corporation

This connector is a standard connector commonly used for Ethernet. The 
StarFabric bridges use the RJ-45 connector with CAT5 cables for a 
board-to-board interconnect.

A pair of CAT5-e cables are required to make a complete link: One cable 
to transmit data and one cable to receive data. You must install these cables 
in a pair. In addition, to meet the specified electromagnetic emissions 
standards, you must install the supplied ferrites on both ends of each cable, 
one ferrite per cable end.

The NI CardBus-8310-to-PXI is available with cables of various lengths. 
Table 1-1 shows the cables that are available from National Instruments.

Before installing the NI CardBus-8310-to-PXI expansion system you 
should perform the following steps.

•

Inventory the shipping carton contents for all of the required parts.

•

Gather all of the necessary tools required for installation.

•

Read the rest of this manual. The installation instructions must be 
followed closely.

Follow these suggested guidelines and cautions while installing.

•

Use only the cables provided by National Instruments.

•

Use keyed connectors (to prevent connecting a cable backwards).

•

Be careful when routing signal cables to your devices.

Table 1-1.  National Instruments CardBus-8310-to-PXI Cables

3 m

3 m StarFabric Cable Set 763640-03, 
779544-03, CBL3S-NI

10 m

10 m StarFabric Cable Set 763640-10, 
779544-10, CBL10S-NI

14 m

14 m StarFabric Cable Set 763640-14, 
779544-14, CBL14S-NI