Справочник Пользователя для Crestron qm-rmc
Crestron QM-RMC
Room Media Controller
choices are Slot (for devices connected to the control system via one of the card
slots on the back panel), or Ethernet. If the connection is through a card slot then
select the slot number from the Slot drop-down list. For Ethernet, select the IP
ID.
slots on the back panel), or Ethernet. If the connection is through a card slot then
select the slot number from the Slot drop-down list. For Ethernet, select the IP
ID.
NOTE: The IP ID and associated IP address of the Ethernet device must be
listed in the IP Table.
listed in the IP Table.
Specify the port (Port A or Port B) that the device is connected to, if applicable.
Next, specify the serial protocol that the device expects. The parameters include
the baud rate, parity, the number of data bits and stop bits, the protocol (RS-
232), and the settings for software or hardware handshaking. This information is
provided by the manufacturer’s documentation.
the baud rate, parity, the number of data bits and stop bits, the protocol (RS-
232), and the settings for software or hardware handshaking. This information is
provided by the manufacturer’s documentation.
“Passthrough Mode” Window
The PC is now communicating directly with the device.
To exit Passthrough mode, simply click Functions | Exit Passthrough Mode. A
system reboot also exits the Passthrough mode.
system reboot also exits the Passthrough mode.
Operations Guide – DOC. 6161
Room Media Processor: QM-RMC
• 27