Справочник Пользователя для jetway s755maxr1a

 
 
 
                                                                                                                                                                                                                                                                                                                                                

 
 
 

 

The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4) for each of the four 
IDE devices that the onboard IDE interface supports.  Modes 0 through 4 provide successively 
increased performance. In Auto mode, the system automatically determines the best mode for each 
device.  The settings are: Auto, Mode 0, Mode 1, Mode 2, Mode 3, Mode 4. 
Primary/Secondary Master/Slave UltraDMA 
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the operating 
environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus master driver).  If 
your hard drive and your system software both support Ultra DMA/33 and Ultra DMA/66, select Auto 
to enable BIOS support.  The settings are: Auto, Disabled. 

IDE HDD Block Mode 
Block mode is also called block transfer, multiple commands, or multiple sector read/write.  If your 
IDE hard drive supports block mode (most new drives do), select Enabled for automatic detection of 
the optimal number of block read/writes per sector the drive can support.  The settings are: Enabled, 
Disabled. 

 

↑↓→←

AC97 Audio Device 
This will determine which on Board  AC97 Codec  Function will use.  The settings are: Enabled, 
Disabled. 
Game Port Address/Midi Port Address 
This will determine which Address the Game Port/Midi Port will use. 
USB Device Function    
Select Enabled if your system contains a Universal Serial Bus (USB) controller and you have a 
USB peripherals.  The settings are: Enabled, Disabled. 

USB Keyboard  Legacy Support 
Select Enabled if your system contains a Universal Serial Bus (USB) controller and you have a 
USB keyboard.  The settings are: Enabled, Disabled. 

SiS180 SATA Controller 
The settings are: Enabled and Disabled