Справочник Пользователя для mulholland omni 1&2

7 

Step A:  Connect the cable 
Refer to figure 5.  

1.  Screw the free end of the cable 

into the tilt bar (1) by turning 
the cable. Once the cable end 
has been full screwed in, 
tighten the ring bolt (1) to 
secure. 

2.  Attach the base of the tilt bar 

to the frame brace. Tighten 
bolt.     

Step B: Connect the side frames to the column 
Refer to figure 6.   

1.  Loosen adjustment levers (1), on the top of 

the frame supports (2) . 

2.  Orientation:  The knee block assembly and 

locking castors should both be at the rear of 
the OMNI. 

3.  Slide the top holes of the frame supports 

onto the ends of the  column 
support tube (3). 

4.  Slightly tighten the 

adjustment levers so the 
width can be adjusted during 
step C.  

1 

Figure 5 

2 

Figure 6 

1 

2 

3