Техническое Руководство для Puls ML60.241 Power Supply
ML60.241
MiniLine
24V,
2.5A,
S
INGLE
P
HASE
I
NPUT
22. A
CCESSORY
DIN-Rail bracket for wall or panel mount:
A suitable DIN-rail bracket is available on request.
The picture of the power supply is for representation only
Buffer module UF20.241
This buffer unit is a supplementary device for DC 24V power supplies. It delivers power to bridge typical mains failures
or extends the hold-up time after turn-off of the AC power. In times when the
power supply provides sufficient voltages, the buffer module stores energy in
integrated electrolytic capacitors. In case of mains voltage fault, this energy is
released again in a regulated process. One buffer module can deliver 20A which can
also be used to support peak current demands.
power supply provides sufficient voltages, the buffer module stores energy in
integrated electrolytic capacitors. In case of mains voltage fault, this energy is
released again in a regulated process. One buffer module can deliver 20A which can
also be used to support peak current demands.
The buffer unit does not require any control wiring. It can be added in parallel to
the load circuit at any given point. Buffer
units can be added in parallel to increase
the output ampacity or the hold-up time.
the load circuit at any given point. Buffer
units can be added in parallel to increase
the output ampacity or the hold-up time.
DC
Buffer
Unit(s)
Power
Supply
Load
AC
+
-
Redundancy module MLY10.241
MLY10
IN 1
+
-
+
-
L
N
N
I
I
ML60.241
L N
Output
Input
+ +
- -
ML60.241
L N
Output
Input
+ +
- -
Output
Load
+
- -
+
-
IN 2
Voltage
Monitor
Monitor
The MLY10.241 is a dual redundancy
module, which has two diodes with
a common cathode included. It can
be used for various purposes. The
most popular application is to
configure highly reliable and true
redundant power supply system
Another interesting applicatio
the separation of sensitive loads
from non-sensitive loads. This avoid
the distortion of the power quality
for the sensitive loads which can
cause controller fail
module, which has two diodes with
a common cathode included. It can
be used for various purposes. The
most popular application is to
configure highly reliable and true
redundant power supply system
Another interesting applicatio
the separation of sensitive loads
from non-sensitive loads. This avoid
the distortion of the power quality
for the sensitive loads which can
cause controller fail
s.
n is
s
ures.
Sep. 2010 / Rev. 1.0 DS-ML60.241-EN
All parameters are specified at 24V, 2.5A, 230Vac input, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.
All parameters are specified at 24V, 2.5A, 230Vac input, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone +49 89 9278 0 Germany
16/22