Техническое Руководство для Cisco 7500 SERIES ROUTE SWITCH PROCESSOR 16
16
Route Switch Processor (RSP16) Installation and Configuration Guide
OL-4661-03
Installing the RSP16
Figure 3
Ejector Levers and Captive Installation Screw
Step 7
Place the removed RSP16 on an antistatic mat or foam. If you plan to return the RSP16 to the factory,
immediately place it in an antistatic bag to prevent ESD damage.
immediately place it in an antistatic bag to prevent ESD damage.
Step 8
Attach the equipment end of the ESD-preventive strap to the RSP16 before performing any maintenance
on the RSP16 that might create an ESD hazard.
on the RSP16 that might create an ESD hazard.
This completes the removal procedure. If you removed the RSP16 to replace DIMMs, proceed to the
. If you are replacing the RSP16, proceed
to the next section to install the new RSP16.
H1482a
Processor module
slot
slot
a
b
c
STOP!
on contact
Bottom ejector lever
Captive
installation
screw
installation
screw
Processor
module
carrier guide
module
carrier guide