Техническое Руководство для Cisco 7500 SERIES ROUTE SWITCH PROCESSOR 16

The RSP16 is keyed for installation only in an RSP slot. By default, the system active is the RSP that
occupies the first RSP slot in the router: slot 2 in the Cisco 7507 and Cisco 7507-MX, and slot 6 in the
Cisco 7513 and Cisco 7513-MX. Follow these steps to install an RSP16:

Grasp the RSP16 handle with one hand and place your other hand under the carrier to support and guide
it into the slot. (See

.) Avoid touching the board or any connectors.

Place the back of the RSP16 in the appropriate RSP slot and align the notches along the edge of the
carrier with the grooves in the slot. (See

a.)

To prevent damage to the backplane, you must install the RSP16 in the RSP slots on the router. The slots
are keyed for correct installation. Forcing the RSP16 into a different slot can damage the backplane and
the RSP16.

While keeping the RSP16 parallel to the backplane, carefully slide the carrier into the slot until the
RSP16 faceplate makes contact with the ejector levers, and then stop. (See

b.)

Using the thumb and forefinger of each hand to pinch each ejector lever, simultaneously push both
ejector levers inward (toward the handle) until they are parallel to the faceplate. (See

c.)

Use a screwdriver to tighten the captive installation screws on the ends of the RSP16. (See

Use a screwdriver to tighten the two captive installation screws on the RSP16 faceplate to prevent the
RSP16 from becoming partially dislodged from the backplane and to ensure proper EMI shielding.
(These screws must be tightened to meet EMI specifications.)

H1355a