Справочник Пользователя для Andrew Wireless System CAPL17E19
ION®-E Series Low Power Carrier Access Point Installation Guide
M0201AAC
Page 26
© February 2018 CommScope, Inc.
Installing CAP Ls
Wall Mount a CAP L Using a Flat Mounting Bracket Kit
1
Follow the steps in
.
2
Refer to and observe all cautions listed in
3
Refer to
to determine the mounting location, which must
be able to support the weight and dimensions of the CAP L.
4
to determine the mounting orientation of the
CAP L.
5
Attach the two mounting brackets to the back of the CAP L enclosure as described below and as shown in
(CAP L with a Fan Kit) and
(CAP L without Fan Kit).
a
Use three of the M6-1.0 x14mm screws that came with the Flat Mounting Bracket Kit to attach the left
or top mounting bracket to the three corresponding horizontal or vertical M6-1.0 mounting taps on
the back of the CAP L chassis.
or top mounting bracket to the three corresponding horizontal or vertical M6-1.0 mounting taps on
the back of the CAP L chassis.
b
Use three of the M6-1.0 x14mm screws that came with the Flat Mounting Bracket Kit to attach the
right or bottom mounting bracket to the three corresponding horizontal or vertical M6-1.0 mounting
taps on the back of the CAP L chassis.
right or bottom mounting bracket to the three corresponding horizontal or vertical M6-1.0 mounting
taps on the back of the CAP L chassis.
Figure 9. CAP L (No Fan Kit) with Flat Mounting Bracket Kit (PN 7774353-xx)
One Mounng bracket
in horizontal posion
Three
M6-1.0 x 14mm
screws
One Mounng bracket
in horizontal posion
Three M6-1.0 x 14mm screws
NOTE: Install a CAP L with
a Fan Kit horizontally.
a Fan Kit horizontally.