Справочник Пользователя для GUANGDONG ROULE ELECTRONICS CO. LTD RL-IP02
Rain shade
Camera
Speaker
Button
Microphone
Wiring terminal
reset
POWER(+ -)
LOCK(NO/COM/NC)
INPUT:100~240 /50~60HZ
OUTPUT:DC12V/1.1A
OUTPUT:DC12V/1.1A
1、Connect with an electric lock
Note: The enclosed adapter in the package is for the main unit, not
the power supply for unlocking.
the power supply for unlocking.
2、Connect with a magnetic lock
INPUT:100~240 /50~60HZ
OUTPUT:DC12V/1.1A
OUTPUT:DC12V/1.1A
- French:
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement."
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement."
2
Panel Introduction
Installation Instruction
1. Install the rain shade on the door at 1.4m~1.7m height up from the ground (according to the
camera's effect), avoid direct sunlight.
camera's effect), avoid direct sunlight.
140-170mm
2. Fix the rain shade with the enclosed screws by referring to the diagram below.
3. Put the outdoor unit in the rain shade after finishing wire connection (see the picture below),
3. Put the outdoor unit in the rain shade after finishing wire connection (see the picture below),
and then fasten the outdoor unit with screws.
②
③
3
Wiring Diagram
IC WARNINGS
English:
1.This device complies with Industry Canada's licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
1.This device complies with Industry Canada's licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body