Справочник Пользователя для Zonoff Inc. EMBY001

Once included into the TaHomA system, the Cooper 5-Button Scene Controller allows End Users to access up to 5 Scenes. The 
Cooper 5-Button Scene Controller must be installed by a licensed electrician following the instructions included with the 
device. As part of TaHomA’s Z-Wave mesh network, the 5-Button Scene Controller will act as a repeater, ensuring commands 
will be transmitted regardless of obstacles or dead spots.

NOTE: Only 1 device at a time can be included into TaHomA.

1.  Make sure the scene controller has power but is not yet included in TaHomA by verifying that all LEDs are blinking. 

2.  In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a device to add to the network” before continuing to the next step.

3.  Briefly press and release the PROGRAMMING button. The LEDs will blink in sequence while the controller is being

included in the system. DO NOT press any other buttons at this time. The LEDs will stop blinking and remain solid. Once 
the Device Finder window displays the message “Found a Device” and the Name and Room drop down menus appear, 
the scene controller has been successfully included into the TaHomA system.

If the Device Finder window hangs in the “Listening for device” state, you may be out of range of the TaHomA 
controller, in which case, you will have to use the USBIC for programming (refer to page 69 for more information 
about the USBIC).

4.  In the Device Editor window, enter a name for the scene controller and assign it to a room.

5.  The scene controller is now fully included in the network.

All LEDs are Blinking Blue: Controller has power but 
is not included in TaHomA.

ALL LEDs are OFF: Controller is included in TaHomA. 

Single LED is Blue (when button is pressed): Scene 
has been activated.

5-Button Scene Controller

To program Scenes to a scene controller, refer to 

Part 2, Section 3.1 of this guide.

NOTE: Only 1 device at a time can be excluded from TaHomA.

1.  In TaHomA’s Device Configurator, click the “Remove Device” button. Wait until the Device Remover window displays the

message “Listening for a device to remove from the network” before continuing to the next step.

2.  Briefly press and release the PROGRAMMING button. TaHomA will remove the scene controller from the system and

the icon will disappear from TaHomA. Once removed from the system, the scene controller’s LEDs will start blinking, 
indicating it is no longer included in TaHomA.

1.  Once Scenes have been created and applied, press the desired scene button to activate a Scene. 
2.  Multiple Scenes may be launched at the same time, and the respective LED will illuminate to confirm launch.

TO BRIGHTEN/DIM: Press and hold the scene button until lights reach the desired level.

1.  Exclude the controller from TaHomA.

2.  On the scene controller, press and hold buttons 1, 3, and 5, for 5 seconds. DO NOT press any other buttons at this time. 

Release buttons 1,3, and 5 and briefly press and release the PROGRAMMING button. The LEDs will blink blue, indicating
the device has been successfully reset and is ready for inclusion in TaHomA. 

5-Button Scene Controller 

cont’d