Справочник Пользователя для GRAUPNER CO. LTD. 19001200

14 / 28

S5012_Alpha_110_jh_V1

The following components are required to use the model: Trans-
mitter HoTT  (MZ-8 / MX-12 / MZ-12 or higher) MZ-8 included 
by S5012.RTF.

For the version S5012.FPV will be required a video goggle or an 
FPV monitor to fly in FPV.

Receiver
The transmitter is already completely set to work properly with 

the Alpha 110 Quadrocopter. To program some parameters, refer 

to the section "Receiver settings".

Installing the battery in the copter
Fix the battery in the battery case. Place the battery so that the 

Alpha 110 Quadrocopter’s center of gravity is in the middle.

The included receiver is already bound to the MZ-8 transmitter 

in the version S 5012.RTF. In the other versions without included 

transmitter, you can bind the copter receiver with your favorite 

HoTT transmitter. Thereto read the manual of your HoTT trans-

mitter. The copter receiver is already in binding mode as soon 

as it is switched on. Then siply start the binding process in the 

transmitter.

Binding with the MZ-8 transmitter
If you want to bind the copter with the MZ-8 transmitter push 

the "LED" button on the transmitter when the copter is switched 

on.
If the binding process was successful the status LEDs will light 

red on the transmitter and green on the copter.

The integrated range test reduces the transmitter output so that 

you can perform a function test at a distance between 5 and 

about 10 m.
Perform the range test for the Graupner-HoTT system according 

to the following instructions. It is useful to have an assistant to 

help you with the range test.
Switch on the transmitter and the copter then wait until the green 

LED on the copter lights. You are now able to monitor control 

movements.