GRAUPNER CO. LTD. 19001200 用户手册
14 / 28
S5012_Alpha_110_jh_V1
TEST VERSION, DO NOT USE FOR PRINTING
Preparation before use
The following components are required to use the model: Trans-
mitter HoTT (MZ-8 / MX-12 / MZ-12 or higher) MZ-8 included
by S5012.RTF.
mitter HoTT (MZ-8 / MX-12 / MZ-12 or higher) MZ-8 included
by S5012.RTF.
For the version S5012.FPV will be required a video goggle or an
FPV monitor to fly in FPV.
FPV monitor to fly in FPV.
Receiver
The transmitter is already completely set to work properly with
The transmitter is already completely set to work properly with
the Alpha 110 Quadrocopter. To program some parameters, refer
to the section "Receiver settings".
Installing the battery in the copter
Fix the battery in the battery case. Place the battery so that the
Fix the battery in the battery case. Place the battery so that the
Alpha 110 Quadrocopter’s center of gravity is in the middle.
Receiver’s binding
The included receiver is already bound to the MZ-8 transmitter
in the version S 5012.RTF. In the other versions without included
transmitter, you can bind the copter receiver with your favorite
HoTT transmitter. Thereto read the manual of your HoTT trans-
mitter. The copter receiver is already in binding mode as soon
as it is switched on. Then siply start the binding process in the
transmitter.
Binding with the MZ-8 transmitter
If you want to bind the copter with the MZ-8 transmitter push
If you want to bind the copter with the MZ-8 transmitter push
the "LED" button on the transmitter when the copter is switched
on.
If the binding process was successful the status LEDs will light
If the binding process was successful the status LEDs will light
red on the transmitter and green on the copter.
Range test
The integrated range test reduces the transmitter output so that
you can perform a function test at a distance between 5 and
about 10 m.
Perform the range test for the Graupner-HoTT system according
Perform the range test for the Graupner-HoTT system according
to the following instructions. It is useful to have an assistant to
help you with the range test.
Switch on the transmitter and the copter then wait until the green
Switch on the transmitter and the copter then wait until the green
LED on the copter lights. You are now able to monitor control
movements.