Справочник Пользователя для myon AG M320-1
For this connection a specifically designed adapter cable may be required.
The analog ouput is designed to be acquired with “single ended” inputs of an
analog-to-digital converter only. No “differential” input configuration must be
used.
analog-to-digital converter only. No “differential” input configuration must be
used.
•
Plug the external power supplies of receiver and charging cradle into a mains power outlet.
You will see several blue LEDs light up inside the receiver. Blue LEDs of the charging cradle
will light up if transmitters are inserted (see Section 5.5).
You will see several blue LEDs light up inside the receiver. Blue LEDs of the charging cradle
will light up if transmitters are inserted (see Section 5.5).
•
You may also turn on your specific recording system (e.g. Vicon) as well as all other
interacting systems (e.g. force plates, etc.).
interacting systems (e.g. force plates, etc.).
5.4
5.4
5.4
5.4 Initial operation check
Initial operation check
Initial operation check
Initial operation check
Please perform the steps below to make sure your system is correctly installed and that it is
functioning as intended. If your system should not pass the tests described below, please first re-
check your sytem's configuration and wiring again, before contacting the support team.
functioning as intended. If your system should not pass the tests described below, please first re-
check your sytem's configuration and wiring again, before contacting the support team.
5.4.1
Visual check of basic functions
•
Preparation
◦ Ensure that the system is configured and connected according to this manual.
◦ Make sure that only the components that were supplied by myon as part of your
shipment are used, such as the D-sub cable, power supplies, etc.
•
Conduction
◦ Switch on all charging cradles and receivers and/or connect them to mains with the
supplied AC adapter.
◦ Insert all transmitters into the respective charging slots of the charging cradle(s).
•
Check
◦ Charging cradle(s)
▪ For proper operation, the LEDs of all charging slots into which a transmitter is
inserted, must be either flashing or be lit constantly.
◦ Transmitters
▪ For proper operation, all of the following conditions must be met:
•
If a transmitter is placed into a charging slot of a charging cradle, the
transmitter's LED must not flash or be lit.
transmitter's LED must not flash or be lit.
•
If a charged transmitter is taken out of its charging slot in a charging cradle, the
transmitter's LED has to start flashing for about 2 minutes. If the transmitter is
inserted back into a charging slot again, the transmitter's LED has to stop
transmitter's LED has to start flashing for about 2 minutes. If the transmitter is
inserted back into a charging slot again, the transmitter's LED has to stop
Date: 03.06.2013
LaInMa-EU-m320 - Instructions manual (full version, english) - 20130603 - V1.7.odt
Page 17 of 32