Справочник Пользователя для myon AG M320-1

Image 8: Carrying case

•

Carrying handle

•

Fasteners (push to open
or close)

5.3

5.3 Device installation

Device installation

The installation of the system must be done by qualified personnel.

•

Place the receiver and the charging cradle on a flat surface.

•

Plug the power connector for the receiver into the power socket on the receiver.
Do the same for the charging cradle. Do not plug in the mains connector, yet.

•

If you purchased a receiver with digital output, connect a USB cable's connector to the USB
socket of the receiver and the other end of the USB cable to the 3rd party unit (e.g.
notebook) you wish to use

•

If you purchased a receiver with analog output, you will have to connect the socket for
analog output signals to your specific recording system (e.g. Vicon):

◦ Dismantle each individual cable of the supplied DSub cable that you intend to connect

to your individual analog capture unit.

◦ Connect each individual cable of the supplied DSub cable to the relevant screw terminal

for the analog capture unit you wish to use.

◦ Make sure that electric ground is correctly connected.

◦ Make sure you chose the correct assignment of the individual pins (see Section 9.2 for

details).

◦ Connect the 25-pin DSub cable plug to the analog output connector of the receiver.

For the preparation of this interface specific technical knowledge may be
required. If you do not have the necessary skills, please consider consulting an
expert.

Date: 03.06.2013

LaInMa-EU-m320 - Instructions manual (full version, english) - 20130603 - V1.7.odt

Page 16 of 32