Справочник Пользователя для Datastrip Inc. DSV2SC01
DSV2+
Turbo
User Manual, Version 1.09
45
Copyright © 2006 by Datastrip, Inc. All rights reserved.
Reproduction in whole or in part is prohibited.
•
ActiveSync via the Docking Station”. Then remove the DSV2+ from the docking cradle.
•
Connect the PC (wired/wireless) to a network which has a wireless router. Test the
connection before proceeding further.
•
Configure ActiveSync to support this connection, [FILE] à [CONNECTION
SETTINGS…]
•
Select the option “Allow network (Ethernet) and RAS server connection with this
computer”. Uncheck “Allow serial cable or infrared connection to this COM port”.
•
Click OK.
16.4.5 PC Configuration for Bluetooth
16.5 If connecting the DSV2+ to the host PC via 802.11 for the first
time, start by establishing a wired ActiveSync connection with the
PC using the procedure described in Section 16.2 ActiveSync via
USB 2.0 Client Port
PC using the procedure described in Section 16.2 ActiveSync via
USB 2.0 Client Port
16.5.1 Hardware/Software Requirements
The following is required to establish an ActiveSync connection via the USB 2.0 Client Port:
The following is required to establish an ActiveSync connection via the USB 2.0 Client Port:
•
ActiveSync version 3.7.1 or later installed on the host PC (Version 4.5 recommended)
•
A DSV2+ terminal with USB 2.0 enabled.
•
USB 2.0 to Mini B Cable – Datastrip sales code – DSVOSCAUSB.
•
Datastrip DSV2+_Turbo_USB Sync Setup utility found on the DSV2+ User Manual CD.
16.5.2 PC Configuration for USB 2.0 ActiveSync (First Time Only)
•
Run the “DSV2+_Turbo_USB Sync Setup” utility found on the DSV2+ User Manual CD
•
After running the Sync setup you will be prompted to connect your DSV2+ terminal to
the PC. Turn your DSV2+ terminal on and connect it to any one of the host PC USB
ports using the USB 2.0 to Mini B cable. After the DSV2+ terminal has been connected,
Windows will notify you that it has “Found New Hardware”. You will then be asked
“Can Windows Update search for new software?” Answer: NO, not this time.
ports using the USB 2.0 to Mini B cable. After the DSV2+ terminal has been connected,
Windows will notify you that it has “Found New Hardware”. You will then be asked
“Can Windows Update search for new software?” Answer: NO, not this time.
•
The Wizard will then ask how you want to install software. Answer: Install the software
automatically (Recommended).
16.5.3 Establishing a Connection
•
Each time you connect the DSV2+ terminal to the host PC you will be asked if you
would like to set up a Partnership. If you will be using this DSV2+ terminal on this PC
regularly then answer “Yes”. If this is a one time use on this PC answer “No”. In either
case you will be connected and can transfer files between the PC and the DSV2+
terminal.
regularly then answer “Yes”. If this is a one time use on this PC answer “No”. In either
case you will be connected and can transfer files between the PC and the DSV2+
terminal.
16.5.4 Troubleshooting the Connection
If a connection is not automatically established check the following:
•
The DSV2+ will not connect while it is in Suspend mode. Wake the DSV2+ from
Suspend prior to connecting the USB cable.