Справочник Пользователя для Outsite Networks Inc. APT-2014
AllPoints Touch Installation Manual
Page 10
Therefore powering on the AP Touch unit is a two-step process:
1. Connect the provided AP Touch power supply to the AP Touch Power port on the
back connection panel of the unit.
2. Connect the AP Touch power supply to the electrical outlet.
Note: There is no power switch on an AllPoints Printer. Cycling power on the AP
Touch Unit requires disconnecting power at the power supply or outlet.
Touch Unit requires disconnecting power at the power supply or outlet.
14. Configure the AllPoints Touch
The AP Touch has several configuration items which may require setting. Setting these
item values maybe accomplished using one of two methods.
14.1.
EZ-Install Application
The AP Touch supports configuration via a PC to AP Touch cable connection and the
browser based EZ-Install application. This is the preferred method of installation
because the browser interface is much easier to use.
To use the EZ-Install application and complete the installation, refer to the provided AP
Touch EZ-Install reference guide.
14.2.
Manual configuration
The AP Touch Manual configuration is accomplished by using the Touch Screen.
14.2.1.
Enter AllPoints Touch Configuration Mode
To enter the Configuration Mode, the Touch Screen is divided into 3 sections as depicted
below; pressing the MIDDLE, BOTTOM and MIDDLE again will bring up the Main
Entry Screen.
TOP
MIDDLE
BOTTOM