Справочник Пользователя для Innovative Technology of America ITATRAN
Innovative Technology of America
ST2000 Safety Transmitter
Installation Procedure - Striping Vehicle
1. Supplied Material
Drill Template
8-32 Button heads screws
Interconnect (power) cable
8-32 Button heads screws
Interconnect (power) cable
2. Tools required
Wire stripper
Screwdriver with “Allen Wrench” head
Screwdriver with “Allen Wrench” head
Drill and #18 bit (8-32 screws) plus 1.2” bit (antenna aperture)
Tube of clear silicon gasket seal
3. Mounting the transmitters
3a.
Place the drill template at the desired location. Drill the four holes with
the #18 bit. Repeat this procedure at the other end of the vehicle. Drill
out the center hole with the 1.2-inch bit.
3b.
Coat the front metal surface only with clear silicon gasket seal.
3c.
With one person inside with the transmitter and one outside align the
transmitter and mount with the 8-32 screws. Wipe off any sealant the may
be on the clear lens of the antenna.
4. Wiring
4a.
Power Connectors.
Connect the black wire to chassis ground.
Connect the red wire to one of the red wires from switch box if manual
turn-on/off of the transmitters is desired.
Otherwise connect red wire to the desired 12-volt power source in the
vehicle.
Connect the green wire to one of the green wires from the switch box.
4b.
Switch box.
Green wires connected per above.
Black wire to chassis ground.
Red wire labeled “power” to 12-volt power in vehicle (manual turn-on/off)
Two red wires (unmarked) per above for manual turn-on/off
NOTE-Red wires are not connected if manual on/off is not desired.
January 1, 2001